€10.00
Angle Fillet Trim for use on flat roof with Lava 20 when connecting to a vertical surface. Use this trim to create a smooth sealed transition from a vertical surface to a horizontal flat surface. The top of the trim, fixed to the vertical surface, should be overlapped with lead or an alternative material which is then overlapped with plaster or what ever finish is to be rendered on the vertical wall. This is to divert any rain that hits the vertical wall and wind from blowing moisture at horizontal level from entering the envelope.
Angle Fillet Trim for use on flat roof with Lava 20
Girth: 260mm, Depth: 125mm, Length: 1.5 metres.
Fitted to the roof where laminate has contact with a vertical surface. Trim is tapered at 45 degree at angle so that any variations or obstacles along vertical joint will be avoided. Apply 30mm beads of trim adhesive to the surfaces every 300mm, rub the trim into place and nail through the top of the trim into the decking.
The trim can be reinforced to avoid deformation. The trim can either be doubled up by slotting a section of extra trim over the section or it can be reinforced with an extra layer of GRP laminate and then tissue to maintain a smooth finish.
